-
Wall
duct with adapters
- Outside
hood with screen
- Inside
register grill
- Gate
valve
- Mounting
hardware (screws)
- Installation
manual
$195.00
(US$)
ASR-50-WD: Through the wall kit
Please
contact
ASR to order
Click
on the image above
to download the installation and operation manual for the
Through the Wall Kit (PDF)
|
|
This
easy-to-install kit allows you to route your intake hose through
a wall. It comes complete with everything necessary to install
it - except for a few simple hand tools.
This
kit allows you to convey air through a wall - without letting
the air leak into the inside of wall. It has a duct that goes
through the wall with adapters on each end that allow you
to quick-connect the safe cell on one side of the wall and
have one of two adapters on the other side: either an outside
water-shedding hood or an inside register grill. Whether you
are going from your safe room to the outside or to an adjacent
room, this kit has everything you need.
Also
included is a gate valve that will seal the duct so that humidity
cannot migrate up through the duct, through the intake hose
of the Safe Cell and moisten the carbon
adsorber - lessening it's life. This gate valve can be
instantly opened by hand when turning on the Safe Cell. Shown
below, it's in its up (or open) position:
click
image to enlarge
click
image to enlarge
The Through the Wall Kit from the outside
after the hood has been painted to match the exterior color
of a home
click
image to enlarge
Close-up of above
|
